High Grade Brushes Plus Two Ways To Control Brush Spread
Easy-to-fit Heat Shrink Tubing or roll-on "O" Rings squeeze Engine Turning Brush bristles together so they don't spread out. Keeps those crisp, sharp, deep "swirls" that set a professional jeweling job apart from the rest. Adds a new dimension to your jeweling capabilities; increases brush life too! For the absolute best results, do all your jeweling with the Brownells E/T Brush Holder. Heat Shrink Tubing goes on easily; just cut into ¼" sections, slip over end of brush and heat with a match, hair dryer or heat gun.
SPECS: Set includes: (6), 3/16" (4.8mm) diameter brushes; (12), ¼" (6.3mm) diameter "O" rings; and (1), 4" (10cm) length of heat shrink tubing (enough for 16 pieces).
Mer...
Kundernas betyg påBROWNELLS ENGINE TURNING BRUSH SET
Antal betyg: 1
Från brownells.com: 1
Medelbetyg: 2
Not quite what it is cracked up to be(2009-09-10)
The "o" ring washer does not work very well. However, the shrink wrap does seem to hold the bristles together better. The best way I have found to get consistent swirls is to grind the bristles down to about 1/16". This does reduce the life of the product greatly, but the results are much better.
Produktnr: 080558000 BROWNELLS ENGINE TURNING BRUSH SET050806101159 Lättmonterade värmekrympslangar eller pårullningsbara "O" -ringar pressar ihop motorvridborstborsten så att de inte sprids ut. Håller de skarpa, skarpa, djupa "virvlarna" som skiljer ett professionellt juveljobb från resten. Lägger till en ny dimension till dina juvelfunktioner; ökar borstens livslängd också! För absolut bästa resultat, gör alla dina juveler med Brownells E/T Borsthållare. Värmekrympslang går lätt på; skär bara i 1/4 "sektioner, glid över borstens ände och värm med en tändsticka, hårtork eller värmepistol.
High Grade Brushes Plus Two Ways To Control Brush Spread
Easy-to-fit Heat Shrink Tubing or roll-on "O" Rings squeeze Engine Turning Brush bristles together so they don't spread out. Keeps those crisp, sharp, deep "swirls" that set a professional jeweling job apart from the rest. Adds a new dimension to your jeweling capabilities; increases brush life too! For the absolute best results, do all your jeweling with the Brownells E/T Brush Holder. Heat Shrink Tubing goes on easily; just cut into ¼" sections, slip over end of brush and heat with a match, hair dryer or heat gun.
SPECS: Set includes: (6), 3/16" (4.8mm) diameter brushes; (12), ¼" (6.3mm) diameter "O" rings; and (1), 4" (10cm) length of heat shrink tubing (enough for 16 pieces).
Mer...
Kundernas betyg påBROWNELLS ENGINE TURNING BRUSH SET
Antal betyg: 1
Från brownells.com: 1
Medelbetyg: 2
Not quite what it is cracked up to be(2009-09-10)
The "o" ring washer does not work very well. However, the shrink wrap does seem to hold the bristles together better. The best way I have found to get consistent swirls is to grind the bristles down to about 1/16". This does reduce the life of the product greatly, but the results are much better.