Brownells Sverige - Komplett utbud av laddutrustningar, vapendelar, skyttetillbehör, kulor, hylsor och optik Sverige
076683350015 100060677
This 7.62x39mm Two-Die Full Length Die Set is intended for reloading bottleneck cases, and consists of a Full-Length Sizer Die with an Expander-Decapping Unit, and a Seater Die with Bullet Seater Plug. The Full-Length Sizer Die brings the case to SAAMI minimum cartridge dimensions. It sizes the outside of the case, de-primes and expands the neck to accept the bullet. The die has vents to prevent case damage caused by trapped air and for excessive lubricant. Headspace is held to minimum tolerances to avoid changing the case body length during full length sizing. The included Seater Die has a built-in roll crimper to secure the bullet at the same time as it’s seated.
899 899 1 SEK
Produktnr: 100060677
RCBS 7.62X39MM FULL LENGTH DIE SET
Tillverkarens produktnummer: 35001 076683350015 Detta 7.62x39mm två-dies fullängdsset är avsett för omladdning av flaskhalspatroner och består av en Full-Length Sizer Die med Expander-Decapping Unit, och en Seater Die med Bullet Seater Plug. Full-Length Sizer Die återför hylsan till SAAMI:s minimimått för patroner. Den dimensionerar hylsans yttre, avlägsnar tändhatt och expanderar hylshalsen för att acceptera kulan. Die:en har ventilationshål för att förhindra skador på hylsan orsakade av instängd luft och för mycket smörjmedel. Utrymmet för huvudutrymmet hålls till minimala toleranser för att undvika att förändra hylskroppens längd under fullängdsdimensionering. Den medföljande Seater Die har en inbyggd rullkrämpare för att säkra kulan samtidigt som den sätts på plats.
899 SEK 0 899,00 kr *
Restorder. Skickas när den finns i lager. Leveranstid ca 4-12 veckor från centrallagret.
Funktioner: Laddverktyg: Full Length Die Set Patron: 7.62 x 39 mm

Produktinformation

Laddverktygstyp: Full Length Die Set Patron: 7.62 x 39 mm Leveransvikt: 0,454kg Leveranshöjd: 51mm Leveransbredd: 102mm Leveranslängd: 127mm

Produkt detaljer

Tillverkas i USA



This 7.62x39mm Two-Die Full Length Die Set is intended for reloading bottleneck cases, and consists of a Full-Length Sizer Die with an Expander-Decapping Unit, and a Seater Die with Bullet Seater Plug. The Full-Length Sizer Die brings the case to SAAMI minimum cartridge dimensions. It sizes the outside of the case, de-primes and expands the neck to accept the bullet. The die has vents to prevent case damage caused by trapped air and for excessive lubricant. Headspace is held to minimum tolerances to avoid changing the case body length during full length sizing. The included Seater Die has a built-in roll crimper to secure the bullet at the same time as it’s seated.
Nyhetsbrev