Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Razor, C-More RTS or STS red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount does not fit: Ruger Flattop Revolvers
Uppgradera din Ruger revolver med EGW Sight Mount!
Med EGW Sight Mount kan du enkelt byta ut bakre sikte på din Ruger revolver för att montera din Vortex Razor, C-More RTS eller STS rödpunktsikte. Följ instruktionerna nedan för en smidig installation.
Produktbeskrivning
- Ta bort det bakre siktet*
- Installera EGW Sight Mount i spåret
- Dra åt inställningsskruven (om tillämpligt)
- Placera rödpunktsiktet på EGW Sight Mount (lägg en liten bit papper mellan rödpunktsiktet och siktet för enklare borttagning och för att hålla Loctite borta från rödpunktsiktet)
- Tillämpa blå Loctite på de medföljande monteringsskruvarna
- Dra åt monteringsskruvarna till 15in/lbs
De skruvar som ingår med detta fäste kräver en 5/64'' insexnyckel för installation. Observera att detta fäste inte passar:
* Följ alltid säkerhetsföreskrifterna när du arbetar med vapen.