EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. Does not fit: Springfield XD(M)® 5.25"" COMPETITION SERIES MODEL Any Optics Ready Springfield XD
Kraftfull och pålitlig siktmontering för Springfield XD
EGW:s siktmontering för Vortex Viper/Venom är designad för att enkelt installeras på din Springfield XD. Med en progressiv taper i spåret, blir installationen smidig och effektiv.
Produktbeskrivning
EGW:s rödpunktsikter är avsedda att installeras från vänster till höger (med mynningen framåt). Följande steg beskriver installationsprocessen:
- Ta bort bakre sikt*
- Installera EGW Sight Mount i spåret
- Dra åt setskruven (om tillämpligt)
- Placera rödpunktsikten på EGW Sight Mount (genom att lägga en liten bit papper mellan rödpunktsikten och siktmonteringen blir det enklare att ta bort och håller Loctite borta från rödpunktsikten).
- Tillämpa blå Loctite på de medföljande monteringsskruvarna
- Åtdragning av monteringsskruvarna till 15in/lbs
Inkluderat:
- 2 Button Head Cap Screws - För Vortex Viper och Venom Sights
- 2 Flat Head Cap Screws - För Burris FastFire och Docter Sights
Skruvarna som ingår med denna montering kräver en 5/64'' insexnyckel för installation.
Observera att modifiering av ditt vapen kan ogiltigförklara tillverkarens garanti. Produkten bör installeras och kontrolleras av en kvalificerad vapensmed. Ingen ansvarighet uttrycks eller underförstås för skador eller skador som kan uppstå från felaktig installation eller användning av denna produkt.
Passar ej:
- Springfield XD(M)® 5.25" COMPETITION SERIES MODEL
- Alla Optics Ready Springfield XD