FHD FLASH HIDERS These fit the plan B type mounts. This is an updated version that has larger wrench flats on the rear. Always use an alignment rod to ensure that the entire system is set up correctly. Make sure all surfaces are cleaned and the muzzle device has been torqued and Rockset to the barrel. Use on a Q can voids your warranty, be warned. Torque the muzzle device to approximately 30 ft lbs. Make sure the muzzle device is square against the shoulder. When setting the silencer on the muzzle device, ensure that the threads and tapers are clean. Torque the suppressor to 10 ft lbs. Ensure alignment. Enjoy. The nitride finish does lead to a tighter seal, with that said, it is extremely important to torque and rockset your muzzle device to the barrel properly. FEATURES: 17-4 PH H900 Atlas and Atlas XL Compatible Plan B Compatible Atlas XL Adapter No Overrun Black Nitride Finish (67 HRC Surface Hardness) Shims Not Included, if you would like to specifically time this, shims will be required. Note: your barrel may require a shim if the manufacturer did not put a thread relief on it.
FHD FLASH HIDERS – Perfekt för Plan B-monteringar!
FHD FLASH HIDERS är utformade för att passa Plan B-typ monteringar. Denna uppdaterade version har större skruvflats på baksidan. Använd alltid en justeringsstav för att säkerställa att hela systemet är korrekt inställt.
Se till att alla ytor är rengjorda och att mynningstillbehöret är åtdraget och Rocksetat till pipan. Användning av en Q-dämpare annullerar din garanti, var försiktig. Åtdrag mynningstillbehöret till cirka 30 ft lbs. Kontrollera att mynningstillbehöret är rakt mot axeln.
Montering av dämpare
När du sätter dämpare på mynningstillbehöret, se till att gängorna och konerna är rena. Åtdrag dämpare till 10 ft lbs. Kontrollera justeringen. Njut!
Den nitridfinishen ger en tätare försegling, och det är extremt viktigt att åtdra och Rockseta ditt mynningstillbehör till pipan på rätt sätt.
Funktioner:
- 17-4 PH H900
- Kompatibel med Atlas och Atlas XL
- Plan B-kompatibel
- Atlas XL-adapter utan överdrag
- Svart nitridfinish (67 HRC ythårdhet)
- Shims ingår inte, om du vill tidsinställa detta specifikt, krävs shims. Obs: din pipa kan behöva en shim om tillverkaren inte har gjort en gängfrisättning på den.