EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount does not fit: Kimber Micro Kimber Micro 9
KIMBER FIXED SIGHT VORTEX VIPER/VENOM SIGHT MOUNT – Perfekt för din Kimber 1911
EGW:s red dot sights är designade för att installeras från vänster till höger (med mynningen vänd framåt). Dovetailen har en progressiv taper för att underlätta installationen. Ta helt enkelt bort bakre siktet på ditt vapen och ersätt det med EGW-monteringen för att montera din Vortex Viper/Venom, Burris FastFire eller Docter red-dot sight. Du kan ta bort monteringen och sätta tillbaka ditt bakre sikt när som helst.
Installationsinstruktioner
- Ta bort bakre sikt*
- Installera EGW Sight Mount i dovetailen
- Dra åt setskruven (om tillämpligt)
- Placera red dot sight på EGW Sight Mount (att placera en liten bit papper mellan red dot sight och sight mount underlättar borttagning och håller Loctite borta från red dot sight.)
- Tillämpa blå Loctite på de medföljande monteringsskruvarna
- Dra åt monteringsskruvarna till 15in/lbs
Ingår:
- 2 Button Head Cap Screws - För Vortex Viper och Venom Sights
- 2 Flat Head Cap Screws - För Burris FastFire och Docter Sights
Skruvarna som ingår med denna mount kräver en 5/64'' allennyckel för installation.
Observera: Modifiering av ditt vapen kan ogiltigförklara tillverkarens garanti. Denna produkt bör installeras och kontrolleras av en kvalificerad vapensmed. Ingen ansvarighet uttrycks eller antyds för skada eller skada som kan uppstå från felaktig installation eller användning av denna produkt.
Denna mount passar inte:
- Kimber Micro
- Kimber Micro 9