Produktinformation
- Modell:
M14
,M1A
- Vapentyp:
Springfield
- Leveransvikt: 0,091kg
- Leveranshöjd: 5mm
- Leveransbredd: 76mm
- Leveranslängd: 122mm
Produkt detaljer
USA: s exportklassificering: 0A501.x
Produktnr: 100002329
Tillv.nr.: 10026
Ventilerad ståldesign ändrar cykeltiden genom att låta dig justera gasvolymen i cylindern. Snabb justering av ventilens storlek med integrerad skruv; eliminerar behovet av att byta skruvar för olika ventilstorlekar. Minskar slitage på op rod, bolt lugs, mottagare och avtryckargrupp. Finns för M1 Garand och M1A.Utgått från Brownells
MA ADJUSTABLE GAS SYSTEM från SCHUSTER är designat för att spara slitage på bolt lugs och mjuka upp stöten på op rod.
Det ventilerade ståldesignen förändrar cykeltiden genom att låta dig justera gasvolymen i cylindern. Snabb justering av ventilstorlek med integrerad skruv; eliminerar behovet av att byta skruvar för olika ventilstorlekar. Detta system minskar slag på op rod, bolt lugs, mottagare och avtryckargrupp.
Tillgänglig för M1 Garand och M1A.
M14,
M1A
Springfield
Must Have 2017-05-18
Must have part for an m1 if you want to shoot it a lot or don't reload and don't have access to surplus. I'm going to tune mine for modern 180 grain hunting loads, since that's the most common ammo I can get. Better to use new ammo too because it's not corrosive or dirty. If you don't have the tool to change the plugs out, a large flathead screwdriver will work. Set screw is a little tricky to get started, but it works well.
Hard to install Adjust Gas Plug, M1A, 2014-04-24
I bought this product a couple weeks ago to use on my Spfld Arm. inc. M1A and had trouble screwing it in a Military spec. gas cylinder...at first I thought that it was the wrong thread, but a closer comparison revealed that they were correct, just super tight....I used Krills oil on both threads and turning it a 1/8 of a turn at a time using a 1/2" combo wrench it went home....I took the weapon to the range and ran some Tulammo through it. I had to adjust (tune) the valve per instructions and the M1a operated great...it dropped the cases 2 feet away, kinda just barely making it out of the weapon.....no strain on the op rod at all...it is worth the money if you consider how much an M14 op rod cost to replace....
Vi stötte på ett fel när vi laddade innehållet. Vänligen uppdatera sidan för att fortsätta. Om problemet kvarstår, kontakta vår kundtjänst.