The Sinclair Bullet Seating Depth Tool has been used for decades by handloaders seeking the most accuracy out of their rifles. Our newest model is made from one fourth inch ground and polished stainless steel with one end turned down for use with 17 and 20 caliber rifles and the other end used for 22 caliber and up. This tool helps you determine the length of a loaded round touching the rifling. The Sinclair Seating Depth Tool will work with most bolt action, single shot and AR type rifles. The tool includes a Delrin action guide suitable for most bolt-action rifles (0.690” Diameter fits Remingtons, Savages, Winchesters, and many Rugers). For the most accurate measurement, the Sinclair Bullet Seating Depth Tool uses your fireformed brass and bullets so you can expect an exact measurement, every time. Also available are guides use in AR-15's, AR-10's, and Tubb's 2000's. The guide is a little different than our standard bolt-action guides. This guide inserts into the back of the upper receiver (with the bolt removed). The tool is then used as normal. For best results couple this tool with our Bullet Comparators and a good set of calipers to get repeatable and precise Base-To-Ogive measurements.
Optimal precision för dina vapen med Sinclair Bullet Seating Depth Tool!
Sinclair Bullet Seating Depth Tool har använts i årtionden av handladdare som söker maximal noggrannhet från sina gevär. Vår senaste modell är tillverkad av en fjärdedels tum slipat och polerat rostfritt stål, med ena änden nedskuren för användning med 17 och 20 kaliber gevär, och den andra änden för 22 kaliber och uppåt.
Produktfunktioner:
- Hjälper dig att bestämma längden på en laddad patron som rör vid landskapet.
- Fungerar med de flesta lås- och enskottsgevär samt AR-typ gevär.
- Inkluderar en Delrin action guide som passar de flesta låsgevär (0.690” Diameter passar Remingtons, Savages, Winchesters och många Rugers).
- För den mest exakta mätningen använder Sinclair Bullet Seating Depth Tool din formade mässing och kulor för att säkerställa en exakt mätning varje gång.
- Även guider för AR-15, AR-10 och Tubb's 2000 finns tillgängliga.
Guiden är lite annorlunda än våra standard låsgevärsguider. Denna guide sätts in i baksidan av den övre mottagaren (med slutstycket borttaget). Verktyget används sedan som vanligt. För bästa resultat, kombinera detta verktyg med våra Bullet Comparators och en bra uppsättning skjutmått för att få upprepade och precisa Base-To-Ogive-mätningar.