EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with the mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.
Kompakt och pålitlig siktesmontering för Taurus G2/G3
EGW:s red dot-sikten är designade för att installeras från vänster till höger (med mynningen framåt). Dovetailen har en progressiv avsmalning för enklare installation. Ta helt enkelt bort bakre siktet på din pistol och ersätt det med monteringen för att montera din Vortex Viper/Venom, Burris FastFire eller Docter red-dot sikte. Du kan ta bort monteringen och återinstallera ditt bakre sikt när som helst. Monteringshårdvara ingår.
Installationsinstruktioner
- Ta bort det bakre siktet*
- Installera EGW Sight Mount i dovetailen
- Dra åt setskruven (om tillämpligt)
- Placera red dot-siktet på EGW Sight Mount (att placera en liten bit papper mellan red dot-siktet och siktesmonteringen underlättar borttagning och håller Loctite borta från red dot-siktet.)
- Tillämpa blå Loctite på de medföljande monteringsskruvarna
- Dra åt monteringsskruvarna till 15in/lbs
Inkluderade skruvar:
- 2 Button Head Cap Screws - Medföljande för Vortex Viper och Venom Sights
- 2 Flat Head Cap Screws - Medföljande för Burris FastFire och Docter Sights
Skruvarna som ingår med denna montering kräver en 5/64'' insexnyckel för installation.
Observera: Modifiering av ditt vapen kan ogiltigförklara tillverkarens garanti.
Denna produkt bör installeras och kontrolleras av en kvalificerad vapensmed.
Ingen ansvarighet uttrycks eller antyds för skador eller skador som kan uppstå från felaktig installation eller användning av denna produkt.