Produktinformation
- Patron:
32 Auto (ACP)
- Stil: -
- Leveransvikt: 0,022kg
- Leveranshöjd: 15mm
- Leveransbredd: 97mm
- Leveranslängd: 127mm
- UPC: 734307905248
Produktnr: 430108715
Tillv.nr.: 90524
734307905248 Universell hylshållare som används i de flesta märken av omladdningspressar. Kommer inte att fungera med Lee Auto Prime. Se Lee hylshållartabell.Restorder. Skickas när den finns i lager. Leveranstid ca 4-12 veckor från centrallagret.
Den UNIVERSAL SHELL HOLDER från LEE PRECISION är en pålitlig och mångsidig lösning för alla dina omladdningsbehov.
Denna hylseholder är idealisk för både nybörjare och erfarna skyttar som vill ha en effektiv lösning för sina omladdningsprojekt. Med sin universella passform är den ett måste i varje verktygslåda för skytteentusiaster.
32 Auto (ACP)
Modified for Sinclair priming tool 2017-12-13
The Sinclair priming tool is in my opinion the best for accurately and consistently seating primers. However, for .338 LM (based on .416 Rigby) there are not a lot of options. The proper Sinclair holder is backordered from Brownell.
However the Sinclair tool accepts Lee hand priming tool shell holders and the #8 Lee shell holder fits and can be installed into the Sinclair tool by facing off the lug that holds the shell holder into a press thus converting it to a Lee priming-type shell holder, in other words just make this holder flat across the bottom as are the Lee priming shell holders. I did this easily in the lathe, a 5 minute job.
You may also need to modify the primer cup in the Sinclair tool to allow a case to fit smoothly. I took .025 off the lip of the cup to match the shell holder floor. The Sinclair plunger is adjustable (see their directions) and it sets primers just below flush when is set to .010 above the lip of the primer cup.
Vi stötte på ett fel när vi laddade innehållet. Vänligen uppdatera sidan för att fortsätta. Om problemet kvarstår, kontakta vår kundtjänst.