Produktinformation
- Make: -
- Modell: -
- Leveransvikt: 0,091kg
- Leveranshöjd: 8mm
- Leveransbredd: 79mm
- Leveranslängd: 157mm
- UPC: 050806008304
Produktnr: 080097100
Tillv.nr.: BOLTBODYONLY
050806008304 Fjäderbelastat verktyg ger konstant, rakt bakåt tryck för att hålla bolt lugs kvadratiska mot mottagaren medan man lappar med 600 till 800 grit, silikonkarbid slipmedel. Ger bättre resultat än enbart tumtryck. Utbytbara gängade ärmar passar populära åtgärder som listas nedan.Levernastid ca. 14-21 dagar.
Med BROWNELLS BOLT LAPPING TOOLS får du ett verktyg som ger konstant tryck för att säkerställa att låsningarna är i perfekt vinkel mot mottagaren under lappning med 600 till 800 grit, kiselkarbid slipmedel.
Det fjäderbelastade verktyget ger konstant, rakt bakåt tryck vilket ger bättre resultat än bara tumtryck. Det har en utbytbar design som passar populära vapenmodeller listade nedan.
Kit innehåller alla verktyg som behövs för att lappa alla modeller som anges i tabellen. Specialpris, se nedan.
Very nice fit of parts. 2015-08-31
I bought this one-gun kit after trying to use the plunger body from the M14/M1/M1A kit. It did not fit a sleeve I had bought for the Large Ring Mauser. After receiving this kit with it's plunger body I then began trying all the parts one at a time.
Both plunger bodies are 0.5620" and the sleeves are 0.5625 except the M14, it was 0.563. There were little burrs on the plunger body of the M14 kit that made me think it would not fit the different sleeves. All fit well after a little lapping.
I plan on using the bolt lug lapping tool for several rifles I am building. After using the tool I believe I can use it to square the bolt face on a Mauser Large Ring VZ-24. After reaming the sleeve from existing 9/16" to a 5/8" I will press fit a drill bushing that is 5/8 x 3/8 and use the Mason Reamer Burr which has a 3/8" shaft. The Burr has been ground to 0.3740 to 0.3745. It has a buttery slip fit in the Drill Bushing.
Mauser threads are at a 55 deg pitch and not easy to find. Brownells sells the sleeve with the right threads for the '98 and the face truing Burrs. All you need is the drill bushing, the undersized drill, and the reamer to make the altered sleeve to be able to Lapp the lugs with the original unaltered sleeve, and true the face of your bolt with your altered sleeve. After, of course, you check that the receivers threads are true to the action. This can be checked with a mandrel which Brownells has too. This can be done for any rifle that Brownells has a sleeve for. Happy Gunsmithing, JL.
Vi stötte på ett fel när vi laddade innehållet. Vänligen uppdatera sidan för att fortsätta. Om problemet kvarstår, kontakta vår kundtjänst.