Produktinformation
- Kaliber:
Universal
- Leveransvikt: 1,338kg
- Leveranshöjd: 112mm
- Leveransbredd: 163mm
- Leveranslängd: 224mm
Produktnr: 749101349
SINCLAIR Bullet Sorting Stand gör det möjligt för dig att snabbt och noggrant sortera kulor efter bas till ogivlängd. Den svarta granitbasen är helt plan och tillräckligt tung för att stanna där du vill ha den på din laddningsbänk. Den medföljande mätinstrumentet har en spakkontroll för enkel insättning och borttagning av kulor i komparatorerna. Bullet Sorting Stand-komparatorer säljs separat och finns i kaliber 22, 6mm, 6.5mm, 7mm, 30 kaliber och 338 kaliber, eller kan användas med någon av våra hex-komparatorer.Restorder. Skickas när den finns i lager. Leveranstid ca 4-12 veckor från centrallagret.
Sinclair Bullet Checker Stand gör det möjligt för dig att snabbt och noggrant sortera kulor efter bas till ogive-längd. Med en svart granitbas som är perfekt plan och tillräckligt tung för att stanna där du vill ha den på din laddningsbänk.
Uppgradera din sorteringsprocess med Sinclair Bullet Sorting Stand och få den precision du behöver för ditt skytte!
Universal
Lowered my Std Deviation 2017-11-03
This is a really nice tool that is well-built. The marble block is heavy and the tool is quick & easy to set up. I measure base to ogive & sort into groups. Bullets aren't perfect, so when you push them gently into this comparator, they will deform slightly, and you may get different readings - depending on how hard you push the bullets into the comparator. Also, (most importantly) the base of most bullets are not flat - they are usually slightly concave (dish shaped) and you will get different readings, depending there the gauge contacts the base. Neither inaccuracies are the fault of this comparator - they are just part of the inconsistencies of bullet making. Most of the bullet length variance seems to be in the nose length & shape of the meplat (tip). I try to adjust seating depth so that a consistent amount of bullet base is going into the case. I ignore the overall loaded cartridge length. I have been getting lots of sub-6fps standard deviations when doing load testing with this method. Now, if I could just get a nice bullet seater that indexes off the ogive, rather than near the tip or half-way down the nose.
Great tool for accuracy 2017-03-14
If they read and edit these hopefully this review will get published and my previous one deleted. After living with this thing for a year and using it on and off, I finally figured out how to make it work for me. I have the slug type caliber blocks but the HEX nut comparator actually works better for me. Get some sorting bins, at least 8. Number from 2 to 8 or whatever. Start gaging bullets and pay attention to just the 3rd digit after the decimal and drop into the corresponding bins. You will have bullets sorted to approximately 0.001". The gage has a stated accuracy of plus or minus same. So if you have a #5 bin full of bullets, based on the gage accuracy you should actually be between 0.XX4" and 0.XX6". That's as good as this setup will get you. Cheers!
Vi stötte på ett fel när vi laddade innehållet. Vänligen uppdatera sidan för att fortsätta. Om problemet kvarstår, kontakta vår kundtjänst.